Multistage surface pump with 920W of power. 6.7 Amperes. Pump body manufactured in cast iron HT250. Ideal for use as a pressure group with the optional pressure control accessory Garland Head.
Supplied with type C connection for direct connection to the electrical network or to the Garland Head pressure controller without the need for splicing. It has 4 turbines in the pump.
Suction diameter (mm)33
Engine Type.Garland Eléctrico AC
Voltage (V)230
Freq. (Hz)50
Power (kW)0,92
Chassis materialPolipropileno
Maximum flow rate (l/h)6000
Suitable for sludge (Yes/No)No
Cut-off buoy (Yes/No)No
Drive diameter (mm)33
ManualView file
Ficha técnicaView file

MAQUINAS RELACIONADAS

FAQS

What differentiates the Volga 707-4T-V23 within the Garland surface pump range?
It has four turbines and a 920 W motor with a consumption of 6.7 A, above smaller models of the same series. This multi-cell configuration is aimed at installations that need more sustained pressure, such as domestic pressure groups or irrigation with multiple sprinklers.
What maximum flow does it reach and for what uses is it reasonable?
It offers a maximum flow rate of 6000 l/h with clean water. It is suitable for bringing water from tanks or wells to the home, watering orchards and small gardens or pressurizing facilities with several consumption points.
Is it valid for water with mud or solids?
No. It is not suitable for mud nor does it have a cut-off buoy, so it should only be used with clean water. For dirty water or water with impurities, it is advisable to opt for a specific submersible pump for that service.
Can it be automated as a pressure group?
Yes. It is intended to work together with the optional Garland HEAD pressure controller. The type C connection that it incorporates allows it to be plugged directly into the HEAD without the need for cable splices.
What advantage does the HT250 cast iron body provide?
HT250 cast iron is more resistant to wear and internal pressure than technical plastics, which provides useful life when the pump works for many hours or with frequent starts typical of a pressure group.
What type of pipe should be used for suction and delivery?
Both the suction and discharge mouths are 33 mm, so it is advisable to use hoses or accessories compatible with that measurement. For suction, it is advisable to mount a reinforced hose with a foot valve to avoid losing prime, as indicated in the manual.